One of the largest changes in house garages over the previous decade or two has been the prevalence of concrete floor coatings. Up until recently the only area you’d see a floor coating or flooring paint would be in a repair shop or an industrial setting. Now, many homeowners are also realizing the advantages of employing some security due to their concrete garage floor together with the safety benefits it provides to guard against slips and falls.

Installation of epoxy resin flooring is really straight forward but you definitely must devote the time necessary for completely cleaning the present concrete surface. Begin with a power washer and clean off all of the grime and dirt you can. Next, scrub the surface with a detergent and water. Employing a push broom works well with this step since you can apply a lot of downward pressure as you are scrubbing. Last, use a degreaser to remove any oil stains or other petroleum stains, if you do not do this epoxy resin will most likely lift up within a few months. When the floor is totally clean, use a propane or electric space heater through the night to wash it.

A fantastic way to ensure you have all you will need for your resin floor is to buy the materials in a kit form. These kits could be had at most home improvement stores and you can also find great buys online. The kit will tell you how many square meters or feet it will pay for, but usually your true coverage will be a little less. Because of this, be certain to have an excess kit or two on hand because you don’t need to run from coat and have to make a visit to the store while half of the flooring is curing.

It only requires a few oz of hardener to cause a gallon of resin to start the healing procedure. If you don’t work fast together with the mixing and application you will begin to find blobs of epoxy in the mixture. This can really destroy your surface coating. Because of this, it’s ideal to just combine up enough at the same time to pay about a 30 square foot area. Mix this amount, roll it out, then mix a different batch. You need to find that this will make it possible for you plenty of time to get a fantastic covering.

Before the surface tacks over you are going to want to spread out the anti-slip material that comes from the kit. For a garage flooring, the industrial grit works nicely but if you are doing a concrete flooring in the home, like a basement, compared to use the color flakes as they do not often rub bare feet uncooked. You still get slip protection but it’s not too aggressive that your family will complain.